![]() Uses IKEv1 Phase 1 proposals with IPsec Phase 2 proposals. Under IKE (Phase 1) Proposal, choose one of the following options from the Exchange drop-down menu: Main Mode This option is only available if IKEv2 Mode is selected on the Proposals tab. Select this option to support IKEv2 Config Payload. Select a remote network from the drop-down menu. This option is only available if Main Mode or Aggressive Mode is selected on the Proposals tab. Select this option if the remote network requests IP addresses from a DHCP Server in the local network. You can only configure one SA to use this setting.ĭestination network obtains IP addresses using DHCP through this VPN Tunnel Select this option if traffic from any local user cannot leave the firewall unless it is encrypted. Under Remote Networks, select one of the following: Use this VPN Tunnel as default route for all Internet traffic Auto-added rules are created between Trusted Zones and the VPN Zone.ĭHCP over VPN is not supported with IKEv2. Use this option if traffic can originate from any local network or if a peer has Use this VPN tunnel as default route for all Internet traffic selected. Select a local network from the drop-down menu if a specific network can access the VPN tunnel. Under Local Networks, select one of the following: Choose local network from list You can select from the following IDs from the drop-down menu:īy default, the IP Address ( ID_IPv4_ADDR) is used for Main Mode negotiations, and the firewall Identifier ( ID_USER_FQDN) is used for Aggressive Mode.Įnter the address, name, or ID in the Local IKE ID and Peer IKE ID fields. Optionally, specify a Local IKE ID and Peer IKE ID for this Policy. By default, Mask Shared Secret is selected, which causes the shared secret key to be displayed as black circles. To see the shared secret key in both fields, clear the checkbox for Mask Shared Secret. The Shared Secret password must be at least four characters long, and should include both numbers and letters. This is used to set up the SA (Security Association). ![]() In the IKE Authentication section, in the Shared Secret and Confirm Shared Secret fields, enter a Shared Secret password. If the Remote VPN device supports more than one endpoint, enter a second host name or IP address of the remote connection in the IPsec Secondary Gateway Name or Address field (optional). Navigate to NETWORK | IPSec VPN > Rules and Settings.Ĭlick +Add to create a new policy or click the Edit icon if you are updating an existing policy.įrom Policy Type on the General screen, select Site to Site.įrom Authentication Method, select IKE using Preshared Secret.Įnter a name for the policy in the Name field.Įnter the host name or IP address of the remote connection in the IPsec Primary Gateway Name or Address field.To configure a VPN Policy using Internet Key Exchange (IKE) with a preshared secret key Content Filtering Client Control access to unwanted and unsecure web content.Capture Client Stop advanced threats and rollback the damage caused by malware.Cloud Firewall (NS v) Next-generation firewall capabilities in the cloud. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |